Fan motor kit, Mini Classic only

Description

This is the fan motor kit for the Mini Classic Water Distiller.

First, remove the 5 screws around the top of the machine.
Lift the top and place it alongside the machine.
Cut the zip tie holding the blue and yellow wires together.
Remove the 2 wires by holding onto the plastic terminal sides and pulling back.
Move the top to a flat surface to remove the fan.
Use a wrench, or screwdriver, and pliers to remove the 2 screws.
The wrench will hold the nut in place when the screw is removed.
Do the same thing to the screw on the other side of the fan.
Once the screws are removed, you can take off the old fan.
Place the new fan directly where the old one was. Make sure the arrow points towards the grill when attaching.
Reattach the screws to the fan. Use the wrench and screwdriver again to attach the screws. Once attached, place the top along the machine.
Reattach the blue wire to the short white wire. Reattach the yellow and red wires to the short red wire.
You can zip tie the wires or leave them and close the top. Make sure the wires don’t get caught.
Screw the 5 screws back around the top.
Your distiller is now ready to go!